High-quality, three-jaw special clutch with pressed aramid linings (commonly known as Kevlar) for your Puch moped with an E50 engine.
The plates of the centrifugal clutch feature larger lubrication holes, which minimize wear and reduce the weight to just 265 g. All metal parts are made of tough, high-quality S355 steel, which guarantees exceptional durability even under high loads.
We deliberately omitted retaining rings from the clutch plates and replaced them with 1.5 mm-thick washers. The entire E50 clutch is secured with a reinforcement plate and Torx countersunk screws, making the engine-clutch assembly 1 mm thinner overall. This also prevents the reinforcement plate from rubbing against the clutch bells.
Unlike woven aramid linings, these “sheet” clutch linings exhibit higher wear resistance but slip slightly more than the “woven” variant.
Note: This clutch is not suitable for kick-start engines.
You can find individual clutch linings as well as alternative tuning or racing clutches in the accessories section.
A quality product from the Austrian manufacturer A.S.P. - Puch Parts.
| Manufacturer | ASP |
| Thickness | 21.5 mm |
| Area of application | Tuning, Racing |
| Material | Steel |
| Material addition | Aramid (colloquially known as Kevlar) |
| Recording type | Cone mounting |
| Number of jaws | 3 pcs |
| Number of springs | 6 pcs |
| Ø outside | 91.5 mm |
| Puch | E50 |
Accessories & related products
HK clutch "supersport" | Puch Maxi S / N (E50)
Ø outside: 93.3 mm · Manufacturer: HK Clutches · Material addition: Aramid (colloquially known as Kevlar) · Recording type: Cone mounting · Number of jaws: 3 pcs · Number of springs: 3 pcs · Area of application: Cross · Area of application: High End · Area of application: Racing
EUR 390.00
ASP clutch springs reinforced 50 N/mm | Puch E50
Spring design: Pressure spring · Spring rate: 50 N/mm · Ø wire: 1.8 mm · Manufacturer: ASP · Number of components: 3 pcs · Material: Spring steel · Area of application: Racing · Area of application: Tuning · Ø inside: 4.6 mm · Ø outside: 8.2 mm · Total length: 27 mm
EUR 20.50
Explore categories from Clutch
Moped fans also bought
Handlebar fork plate 40 cm curved with chrome strut
Ø outside: 22 mm · Height: 400 mm · Width: 730 mm · Manufacturer: Made in Germany · Material: Steel · Color: Chrome · Surface: chrome-plated · Fork plate holder length: 100 mm · Clamping diameter: 22 mm · Length handlebar ends: 150 mm · Crossbar: Yes · Ø Strut: 14 mm · Mounting type: Fork plate · Strut length: 320 mm
EUR 41.20
Exhaust manifold 28 mm chrome | Puch Maxi S / N, X30 NS, NL
Manufacturer: Made in Portugal · Material: Steel · Surface: chrome-plated · Color: Chrome · Ø inside: 24 mm · Total length: 295 mm · Ø outside: 28 mm · Mounting type: Stud bolts & nuts · Number of fixing points: 2 pcs · Hole spacing outlet: 42 mm
EUR 19.40
Working late? Evening hours on Thursday until 20:00
